USB 1.1(Full Speed) 対応の USB Hub です。外部電源(Self Powered) で動作出来る他、バス電源(Bus Powered) でも動作可能です。
至って普通の作りです。
TI 社の Hub チップを使用しているようです。
Vendor ID / Product ID 0x0451(Texas Instruments, Inc.) / 0x2046 (TUSB2046 Hub) Manufacture string 0 Product string 0 Power 100mA (Bus Powered, Remote Wakeup)
0mA (Self Powered, Remote Wakeup)Class / SubClass / Protocol 0x09 (Hub) / 0x0 / 0x0 Endpipe (total=1) 0x81 (Interrupt-IN), 1byte
Bus Powered 時
T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=12 MxCh=
4
D: Ver= 1.10 Cls=09(hub ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=0451 ProdID=2046 Rev= 1.25
C:* #Ifs= 1 Cfg#= 1 Atr=a0 MxPwr=100mA
I: If#= 0 Alt= 0 #EPs= 1 Cls=09(hub ) Sub=00 Prot=00 Driver=hub
E: Ad=81(I) Atr=03(Int.) MxPS= 1 Ivl=255ms
Self Powered 時
T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=12 MxCh=
4
D: Ver= 1.10 Cls=09(hub ) Sub=00 Prot=00 MxPS= 8 #Cfgs=
1
P: Vendor=0451 ProdID=2046 Rev= 1.25
C:* #Ifs= 1 Cfg#= 1 Atr=e0 MxPwr= 0mA
I: If#= 0 Alt= 0 #EPs= 1 Cls=09(hub ) Sub=00 Prot=00 Driver=hub
E: Ad=81(I) Atr=03(Int.) MxPS= 1 Ivl=255ms
hub.c: new USB device 00:07.2-1, assigned address 2
hub.c: USB hub found
hub.c: 4 ports detected
各 OS 共に動作しなかったケースを見たことがありません。大丈夫でしょう。
Hub に USB 機器を接続して認識出来るか確認しています。
<Home> → <M.D.L.> → <今、そこにある機器、、、かも> → <[M.D.L. 今機器] USB-HUB13GPH (Hub)>
Copyright (c) 2004 Makoto NARA (Mc.N), All rights reserved.
<Terms of Use>